Kenwood TM-D710GA Radio User Manual


 
SIGNALING-3
5 Enter your desired DCS code using the microphone keypad.
Refer to the table below for DCS codes.
DCS Code
023 025 026 031 032 036 043 047
051 053 054 065 071 072 073 074
114 115 116 122 125 131 132 134
143 145 152 155 156 162 165 172
174 205 212 223 225 226 243 244
245 246 251 252 255 261 263 265
266 271 274 306 311 315 325 331
332 343 346 351 356 364 365 371
411 412 413 423 431 432 445 446
452 454 455 462 464 465 466 503
506 516 523 526 532 546 565 606
612 624 627 631 632 654 662 664
703 712 723 731 732 734 743 754
DCS CODE SCAN
This function scans through all DCS codes to identify the
incoming DCS code on a received signal. You may fi nd it useful
when you cannot recall the DCS code that the other persons in
your group are using.
1 Press [TONE] 3 times to activate the DCS function.
• The icon appears on the display when the DCS function is
ON.
Each press of [TONE] changes the selection as follows:
Tone (
) CTCSS ( ) DCS ( ) Cross Tone ( :
default) Off (no display).
2 Press [F], [T.SEL] (1s).
• The icon blinks and “SCAN” appears on the display.
Scan starts when a signal is received.
To reverse the scan direction, turn the Tuning control clockwise
(upward scan) or counterclockwise (downward scan). You can
also press microphone [UP]/ [DWN].
To quit the scan, press [ESC].
When a DCS code is identifi ed, the identifi ed code appears on
the display and blinks.
3 Press the Tuning control to program the identifi ed code in
place of the currently set DCS code.
The DCS function will remain ON. To cancel DCS, press [TONE]
until DCS no longer appears on the display.
• Press [ESC] if you do not want to program the identifi ed code.
• Rotate the Tuning control while an identifi ed code is blinking, to
resume scanning.
USING CROSS TONE
You can set separate signaling types by TX and RX for when you
access a repeater that uses different Encode/ decode signaling.
To turn the Cross Tone function On:
Press [TONE] 4 times to activate the Cross Tone function.
• The ” (default) icon appears on the display when the Cross
Tone function is On.
Each press of [TONE] changes the selection as follows:
Tone (
) CTCSS ( ) DCS ( ) Cross Tone ( :
default) Off (no display).
Selecting a Cross Tone mode
To select the cross tone/code frequency required to access
your desired repeater:
1 Turn the Cross Tone function On.
2 Press [F], [T.SEL].
The Cross Tone setting appears on the display.
3 Rotate the Tuning control to select your desired Cross
Tone setting.
Setting Encode Decode Icon
DCS OFF DCS off
TO DCS Tone DCS
DCS CT DCS CTCSS
TO CT Tone CTCSS
To exit the Cross Tone setting selection, press [ESC].
4 Press any key other than the Tuning control and [ESC] to
complete the setting.