Filter
Top Products
PM-2
PM CHANNEL RESET
To reset the PM channels to their default settings:
1 Turn the transceiver power OFF.
2 Press [F] + Power ON.
3 Release [F].
4 Rotate the Tuning control and select PM RESET.
5 Press the Tuning control.
• A confi rmation message appears on the display.
6 Press the Tuning control again to reset the PM channels.
• Press [BACK] to return to the previous display.
• To exit without resetting the PM channels, press [ESC].
STORING DATA IN PM CHANNELS
1 Confi rm that the following conditions have been satisfi ed:
• The transceiver is in receive mode.
• Scan is not being used.
• Microphone Control is OFF.
2 Confi gure the transceiver with your desired settings.
3 Press [F], [P.IN].
• PM channel numbers 1 to 5 appear and blink at the bottom of the
display.
4 Enter a channel number ([1] to [5]) corresponding to your
desired PM channel.
• The settings are stored in the PM channel.
RECALLING PM CHANNELS
1 Press [PM].
• PM channel numbers 1 to 5 and OFF appear on the bottom of
the display.
2 Enter a channel number ([1] to [5]) corresponding to your
desired PM channel.
• The settings stored in the PM channel are recalled.
• The selected channel number appears on the display.
• When selecting [OFF], the PM channels turn off.
AUTO PM CHANNEL STORE
After you recall a PM channel, this function automatically
overwrites the current PM channel with the present operating
environment when:
• You recall another PM channel.
• You press [PM].
• You switch the transceiver power OFF.
Follow the steps below to activate the Auto PM storage function.
1 Enter Menu mode and access Menu 922.
2 Set to ON.
Note: If you do not recall a PM channel (1 - 5), Menu No. 922 will not appear on
the display.