Filter
Top Products
6
P-110 (En)
Verify that all of the following parts are present before carrying out the assembly procedures.
First, set the MM. AMP switch on the bottom according to the type of your amplifier. (Refer to “Connections” below.)
Parts nomenclature and assembly
Installing the hinges
After connections, remove the plas-
tic tie that retains the tonearm.
Hinge
Dust cover
Removing the plastic tie
Releasing the arm rest lock lever
This until has a built-in RIAA equalizer amplifier, so it can be connected to an amplifier without PHONO (turntable) input jacks.
According to the amplifier, set the MM.AMP switch on the bottom cover.
Caution:
Do not apply oil or lubrication to the motor, tonearm, or any of the turntable’s mechanisms.
Do not plug in the power cord until all connections are completed.
SPEED
45
33
CUT
Dust cover
AC plug adaptor
(Only for some
areas)
Rubber mat
Audio cords
AC cord
Turntable platter
Center spindle
SPEED selector
CUT key
Cartridge
Arm rest
Tonearm
Cueing lever
Arm elevator
EP adaptor
Tonearm
plastic tie
Connections
MM.AMP
OFF
ON
PHONO
L
R
AUX
L
R
MM.AMP
OFF
ON
MM.AMP
OFF
ON
Rear panel of
the amplifier
Audio cord
White
Red
Rear panel of
the amplifier
When the unit is connected
to the PHONO (MM) jacks :
When the unit is connected
to the AUX jacks, etc. :
Motor puller cover