Kenwood P-110 Turntable User Manual


 
3
P-110 (En)
AC voltage selection
This unit operates on 110-120 or 220-240 volts AC . The AC volt-
age selector switch under the motor pulley cover is set to the
voltage that prevails in the area to which the unit is shipped. Be-
fore connecting the power cord to your AC outlet, make sure that
the setting position of this switch matches your line voltage. If
not, it must be set to your voltage in accordance with the following
direction.
Note:
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector switch.
AC voltage selector switch
For the United Kingdom
Factory fitted molded mains plug
1. The mains plug contains a fuse. For replacement, use only a 5-
Amp ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing the fuse in the
molded plug.
3. Do not cut off the mains plug from this equipment. If the plug
fitted is not suitable for the power points in your home or the
cable is too short to reach a power outlet, then obtain an ap-
propriate safety approved extension lead or adapter, or con-
sult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and
dispose of the plug immediately, to avoid a possible shock
hazard by inadvertent connection to the mains supply.
IMPORTANT:
The wires in the mains lead are coloured in accordance with
the following code:
Blue : Neutral
Brown : Live
Do not connect those leads to the earth terminal of a three-pin
plug.
Before applying power
Units are designed for operation as follows.
U.S.A. and Canada ...................................................... AC 120 V only
Europe and U.K. .......................................................... AC 230 V only
Australia ....................................................................... AC 240 V only
*Other countrues ...................... AC 110-120/ 220-240 V switchable
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR
BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
For other countries
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED
TO ALERT THE USER OF THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE
PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC
SHOCK TO PERSONS.
THE EXCLAMATION MARK WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER OF THE
PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERA-
TURE ACCOMPANYING THE APPLIANCE.
The following informations are on the rear.
1. Trade mark.
2. Model number.
3. The double square symbol.
4. Rated supply voltage.
5. Rated mains frequency.
6. Nature of supply.
Move switch lever to match your line
voltage with a small screwdriver or other
pointed tool.
Safety precautions
Caution : Read this page carefully to ensure safe operation.
SPEED
45
33
CUT
220-240V
110-120V