Kenwood MDX-G2 MiniDisc Player User Manual


 
53
EN
Knowledge
section
In case of difficulty
What seems to be a malfunction is not always so. Before calling for service, check the follow-
ing table according to the symptom of your trouble.
Operation to reset
The microcomputer may fall into malfunction when a cord is unplugged and plugged again while the
unit is ON or due to an external cause. In such a case, the microcomputer should be reset as described
below:
Unplug the power cord from the wall outlet and, while holding the ON/STANDBY
key
depressed, plug the power cord again. This initializes the microcomputer. Note that this clears
the previously stored memory.
Common section
Sound is not produced.
\ Increase the volume level. (page 11)
\ Unplug the headphones if they are connected. (page 6)
No sound from the headphones.
\ Check if the headphone plug is inserted properly into the jack. (page 6)
Noise interferes.
\ Install the outside antenna more apart from the streets. (page 5)
\ Turn nearby electrical appliances off.
\ Install the audio system more apart from the TV set or personal computer.
Amplifier / Speaker section
The clock display blinks without changing the figures.
\ Adjust the present time again. (page 7)
Timer operation is not possible.
\ If the present time has not been adjusted or there was a power failure, adjust the present
time. (page 7)
\ Set the timer ON time and OFF time. (pages 43 to 46)
Radio stations cannot be received.
\ Connect the provided AM loop antenna to the AM ANTENNA jack. (page 5)
\ Extend the FM rod antenna and orient it to the direction in which best reception is obtained.
(page 5)
\ Select the correct broadcast band. (pages 8 to 9)
\ Tune to the frequency of the desired station. (page 9)
After a radio station is preset, it cannot be received by pressing the 4 P.CALL or ¢ P.CALL
button.
\ Preset stations with tunable frequencies. (pages 8 to 9)
\ If the preset memory has been cleared because the power cord has been unplugged for a
long period, preset the stations again. (pages 8 to 9)
Continued on next page
\
*5052/50-60/EN 5/29/01, 10:40 AM53