Kenwood KRF-V9993D Stereo Receiver User Manual


 
98
Troubleshooting
PowerTouch
My PowerTouch is not responding
Make sure you are within the operating range for PowerTouch. See
“How is PowerTouch Powered ?” on page␣ 5 of this manual.
Replace the batteries. See Chapter Two of the Connections and Setup
Guide.
If you’re using an IR receiver, make sure it is connected properly and
turned on. See Chapter Four of the Connections and Setup Guide.
Check the contrast of the PowerTouch’s screen is adjusted properly.
See “How Do I See PowerTouch’s Screen More Clearly?” on page 63.
My PowerTouch is beeping. What does that mean?
The following table includes information about PowerTouch beeps:
Number Tone Meaning
1 high Confirms your most recent button push or
touch
1 low Indicates that your most recent button
push or touch could not be performed
2 high Confirms learning or copying
2 low Indicates that learning or copying was not
successful
PowerTouch does not "learn" new commands or functions.
Check that the distance between PowerTouch and the device's remote
is properly set. Do not place the devices remote right against
PowerTouch.
Check whether the PowerTouch is too close to the receiver, a TV, high-
frequency fluorescent lighting or other electrical appliance.
"Learning" may be not carried out with some devices' remote.
I want to clear all the items in PowerTouch and make it to the fac-
tory-set default condition.
While pressing and holding the CONFIRM and VOLUME DOWN
button, use the stylus to press the RESET button at the bottom of the
battery case.