Filter
Top Products
24
Operations
KRF-V7020/V6020/V5020 (En/T)
Convenient functions
Adjusting the sound
Ambience effects
You can make further adjustments to the sound while listening to
playback in the surround mode.
1 Press the SOUND key to select the item you want to adjust.
Each press switches the selection as listed below.
Note that some items are not displayed in certain modes.
BASS (low frequency range sound quality adjustment) %
TREB (high frequency range sound quality adjustment) %
Cch (center speaker level adjustment)
Sch (surround speaker level adjustment)
SW (subwoofer level adjustment)
INPUT (input level adjustment)
• The adjustment item for input level is displayed only when the
monitor function is activated.
2 Use the MULTI CONTROL (TUNING/SKIP) to adjust the setting
as desired.
• The adjustment item is displayed for approximately 8 seconds.
• If you use the remote control (RC-R0508) to perform the above
setting, press the VIDEO key at this point to turn off the remote
control’s own adjustment mode. In this case, the input source is not
switched.
Display dimmer adjustment
The dimmer function lets you select the brightness of the receiver's
display. You might find this useful if you darken your room to watch movies
or listen to music.
SUBWOOFER adjustment (RC-R0508 only)
It is easy to adjust the volume of the subwoofer using the remote control
(RC-R0508).
1 Press the SUBWOOFER key so that “SW” is displayed.
2 Use the VOLUME key to adjust the volume.
Each time you hold down the DISPLAY key for more than two
seconds, the display brightness changes among the three avail-
able settings. Select the brightness level you find most pleas-
ing.
• The adjustable range is -10 dB to +10 dB.
SOUND
TUNING/SKIP
SUBWOOFER
VOLUME
MULTI CONTROL
MULTI CONTROL
SOUND
SOUND
DISPLAY
Input level adjustment (when using the monitor function)
If the input level while using the monitor function is too high, adjust the
input level as described below.
1 Turn on the monitor function. ^
2 Press the SOUND key several times until the “INPUT” indication
appears.
3 Use the MULTI CONTROL (TUNING/SKIP) to adjust the input
level.
• The adjustment mode is displayed for approximately 8 seconds.
• The input level may be adjusted to any one of two settings: 0 and -
6. (The initial setting is 0.)
4 Press the SOUND key to return to the input indication.
s
W
d
B)
A
SP
PRO LOGIC
TUNED
MEMO.
AUTO
ST.
AUTO SOUND
C
R
S
R
LS
L
LFE
DIGITAL
B
S
SW
V
IDEO1
A
SP
PRO LOGIC
S
SW
C
R
L
B
V
IDEO1
A
SP
PRO LOGIC
S
SW
C
R
L
B
V
IDEO1
A
SP
PRO LOGIC
S
SW
C
R
L
B
I
NPUT -6
STEREO
A
SP
MONITOR
TUNED
MEMO.
AUTO
ST.
AUTO SOUND
SW
R
L
B
RC-R0508
RC-R0710