Kenwood KRF-V6020 Stereo Receiver User Manual


 
12
Preparations
KRF-V7020/V6020/V5020 (En/T)
Speaker placement
Subwoofer
Front speakers : Place to the front left and right of the listening
position. Front speakers are required for all surround modes.
Center speaker : Place front and center. This speaker stabilizes the
sound image and helps recreate sound motion. Be sure to connect
a center speaker when using the Dolby 3 Stereo mode.
Surround speakers : Place to the direct left and right, or slightly
behind, the listening position at even heights, approximately 1 meter
above the ears of the listeners. These speakers recreate sound
motion and atmosphere. Required for surround playback.
Subwoofer : Reproduces powerful deep bass sounds.
Front
speaker
Center speaker
Listening
position
Surround
speaker
Although the ideal surround system consists of all the speakers
listed above, if you don't have a center speaker or a subwoofer, you
can divide those signals between the available speakers in the
speaker settings to obtain the best possible surround reproduction
from the speakers you have available. #
Setting up the system
Loading the batteries
Preparing the remote control (RC-R0508)
Insert four AAA-size (LR03) batteries as indicated by the polarity
markings.
3 Close the cover.
2 Insert the batteries.
1 Remove the cover.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. Replace all four batteries with new ones when you notice a shortening
of the distance from which the remote control will operate or if the
remote control blinks 5 times when you press a key. The remote control
is designed to retain set up codes in memory while you change
batteries.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
Remote sensor
Model: RC-R0508
Infrared ray system
6 m
10 m
30˚ 30˚
When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER key on the remote control. When the power comes ON,
press the key you want to operate.
Operating range
(Approx.)