Filter
Top Products
23
Operations
KRF-V7020/V6020/V5020 (En/T)
Ambience effects
Surround Play
DOLBY PRO LOGIC and DOLBY 3 STEREO can be used when playing
video, DVD, or LD software bearing the
mark. DSP
modes can be used with any source.
• Turn ON related components.
• Complete "Preparing for surround sound". #
• Set the INPUT SELECTOR to the component you wish to play back
with surround sound.
Preparations
1
2
Start playing the video software.
Press the LISTEN MODE key to select the listening mode.
Listening mode settings are stored independently for each input.
Each press of the LISTEN MODE key switches the setting as
listed below.
Note that the only listening mode settings that can be used for
playback with the current speaker settings are available.
• DOLBY PRO LOGIC
• DOLBY 3 STEREO
• LIVE (DSP)
• HALL (DSP)
• STEREO
Example with the DOLBY PRO LOGIC mode selected
The channels from which sound will issue are displayed.
LISTEN MODE
LISTEN MODE
LISTEN MODE
P
RO L GIO
A
SP
PRO LOGIC
TUNED
MEMO.
AUTO
ST.
AUTO SOUND
S
SW
C
R
L
B
Adjust the volume.
3
1
2
3
VIDEO
DVD/6CH INPUT
INPUT SELECTOR
DVD 6-channel playback
Using a DVD player or the like equipped with six (5.1) output channels and
the receiver, you can enjoy surround sound playback.
When you try to play a disc other than Dolby Digital (AC-3) such as DTS
CD, no sound is produced or, noise may be heard. To avoid this situation,
make sure that you connect the component to the receiver’s DVD 6CH.
INPUT jacks through a surround processor which can decode the
surround signal you wont to listen to.
Connecting a DVD player which can decode the surround signal itself is
also acceptable.
Preparations
Select “DVD 6ch” as the input source.
• If speaker system B is on when “DVD 6ch” is selected as the input
source, it switches off and speaker system A turns on automatically
(models other than KRF-V5020).
Start playback of the DVD software.
Adjust the volume.
• It is not possible individually to adjust the volume level or sound quality
(SETUP, SOUND) of the separate channels when the receiver is in the
DVD 6ch mode. Adjust the volume with the controls of the DVD player.
For the powered subwoofer, you can adjust the volume of the
subwoofer using the subwoofer’s own volume control.
• When in the DVD 6ch mode, you can still use the volume control,
mute, SPEAKERS (A) key, and dimmer functions.
• Connect your DVD player to the DVD 6ch jacks of the receiver.
• Turn on all other components that will be used.
• Complete “Preparing for surround sound”. #
RC-R0508
RC-R0710
RC-R0508 RC-R0710