Filter
Top Products
KRF-A4020 (En/E2T)
Operations
Preparations
Other
10
Preparing for playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1 Turn on the POWER key to ON.
2 Turn on the power to this receiver by pressing ON/
STANDBY (
) key.
Selecting MD/TAPE 1 (Main unit only)
Select the source name corresponding to the component
connected to the MD/TAPE1 jacks. The initial factory setting
is “TAPE 1”. To change the source name associated with the
MD/TAPE1 jacks to “MD”, follow the steps below:
1 Use the INPUT SELECTOR knob to select “TAPE 1”.
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to “MD”.
• To return to the original indication, repeat the above
procedure.
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system
to be used.
A ON : Sound from the speakers connected to the
SPEAKERS A terminals on the rear panel.
B ON : Sound from the speakers connected to the
SPEAKERS B terminals on the rear panel.
A+B ON : Sound from both the speakers connected to
the SPEAKERS A and B terminals on the rear
panel.
A+B OFF : No sound from the speakers. Use this setting
when listening with headphones.
Listening to a source component
1
Use the input selector (INPUT SELECTOR) to select
the source you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
1 TUNER (frequency display)
2 “CD”
3 “TAPE 1” or “MD”
4 “PHONO”
5 “AUX”
• When selecting an input source by using the remote
control , press the desired input selector key.
• The INPUT SELECTOR on the front panel of the receiver
always cycles through all inputs.
2
Start playback from the selected source.
3
Use the VOLUME CONTROL (VOLUME UP , DOWN)
to adjust the volume.
• The sound of input source cannot be listened to with
TAPE2/MONITOR is ON.
The indicator for the speakers you
want to use should be lit.
Normal playback
SP. A B
INPUT SELECTOR
MULTI CONTROL
MULTI CONTROL
BASS BOOST
BASS BOOST
SOUND
BALANCE
SOUND
SPEAKERS A B
MUTE
POWER
POWER
ON/STANDBY
AUTO
MUTE
SOURCE DIRECT
S. DIRECT
BALANCE
VOLUME UP, DOWN
VOLUME CONTROL