Filter
Top Products
Selecting AUX-name display
Holding down the DISP button for two seconds or more during
the AUX mode, AUX-name display is blinked for AUX-name
selection mode.
Pressing 4 or ¢ button during this mode allows you to select
"AUX" , "TV" , "VCP" , "GAME" or "PORTABLE" in the AUX mode.
The AUX-name selection mode can be exited by pressing the
DISP button or doing nothing for 10 seconds.
• ATT button
Turns down the volume quickly. To return the volume to its
original level, press the button again. Turning the volume up, or
turning it all the way down deactivates the attenuator function.
NOTE
• VOL buttons
Press the 5 button to turn the volume up.
Press the ∞ button to turn the volume down.
• SRC button
Each time you press the SRC button, the mode switches as
follows:
•The mode switches to the next mode from any mode which
cannot be used.
•The external disc control mode will differ depending on the unit
that is connected.
•To enable the selection of External disc control mode 2/AUX
mode, you should connect optional switching adapter KCA-
S210A (which allows you to select both External disc control
mode 2 and AUX mode) or CD changer (KDC-CPS87, KDC-
CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) or
switching adapter CA-C1AX (which allows you to select AUX
mode only).
During the AUX mode, "AUX" (or AUX-name display) will show
in the display. When the CA-C1AX is being used, the AUX Mode
will replace the External Disc Control Mode.
•If you have selected Standby mode, the timer function that
turns the power off automatically will be activated.
To find out how to set the time on the timer, and how to cancel
the timer function, refer to the section on the Power OFF Timer
function under Menu settings (page 36).
NOTE
▼
Tuner mode
▼
Tape mode
▼
External disc control mode 1
▼
External disc control mode 2 / AUX mode
▼
Standby mode
Basic operations
Accessory of the KRC-V879R
Basic Operations of remote control
— 38 —
English
• 4/¢ buttons
Press the 4 button to make decreasing seeks (using the
preset tuning mode).
Press the ¢ button to make increasing seeks (using the preset
tuning mode).
Use to move the cursor left or right during station name input.
• AM/FM buttons
Press the AM button to select the MW and LW bands.
Press the FM button to select and switch between FM1, FM2,
and FM3 bands.
• DIRECT/OK button
Enters and cancells the Direct access tuning mode.
• 38 button
Enters and cancells the Programme Type Selection (PTY) mode.
• Number/letter entry buttons
Press buttons #1-6 to recall preset stations.
Use to enter frequency of the desired station during Direct
access tuning mode.
Tuner features