Filter
Top Products
If the disc changers that were manufactured and sold after 1997
(except for KDC-C560) are connected, you can directly input
letters using the number/letter entry buttons on the remote
control.
Example: Use the following table to enter the name "DANCE".
Continue steps 3 and 4 until all the characters are chosen for
the name.
Press either the NAME.S button on the main unit or the OK
button on the remote control.
The disc name is stored and the disc name preset mode is
cancelled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
•The number of characters and discs whose names can be
stored will differ depending on the disc changer that is
connected. Please see your disc changer manual for details.
•Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.
•If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
•Pressing the reset button does not erase the disc names stored
in a disc changer.
NOTE
6
5
Button to press # Times pressed
Character
#3 1
1#2
#6 2
#2 3
#3 2
“D”
“A”
“N”
“C”
“E”
Store the names of discs to be displayed when played.
Play the disc whose name you want to preset.
•This function is not available for disc changers that do not
feature the Disc Name Preset function.
•The Disc Name Preset function cannot be used during the
Magazine random play as well as whilst a disc title or track title
is displayed.
Hold down the NAME.S button for two seconds or more.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the 4
or ¢ buttons, respectively, on the remote control.
Each time the 38 button is pressed, the characters to be
entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
Direct Alphabet Input
(Function of remote control with number/letter entry buttons)
NOTE
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z
Numerals and symbols: 0~9 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]
Special characters: á
à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä ê
ë
î
ï ô ö û ü ñ ç © Æ › fi
4
3
2
NOTE
1
Presetting Disc Names (DNPS)
External disc control features
— 28 —
English