Kenwood KR-897 Stereo Receiver User Manual


 
KR-897/KR-797 (En)
18
Recording
To record a music source
1 Select the source to be recorded.
Copying tape (Tape dubbing TAPE 2 = TAPE 1)
The input sources are switched in the following order:
1TUNER (frequency display)
2PHONO
3TAPE1 (MD or VIDEO1)
4CD
5VIDEO2
INPUT SELECTOR
2 Select a source other than TAPE 1.
TUNING
BAND
DISPLAY
TAPE2
MONITOR
INPUT SELECTOR
CD
TAPE 2
Lights
÷For copying a tape using a double cassette deck, read the instruction
manual of the double cassette deck.
Copying tape (Tape dubbing TAPE 1 = TAPE 2)
1 Select TAPE 1 with the INPUT SELECTOR control of the
main unit.
2 Play the cassette deck connected to the TAPE 1 jacks and
start recording of the cassette deck connected to the
TAPE 2 jacks.
1 Press the TAPE 2 MONITOR key.
3 Play cassette deck 2 and start recording
on cassette deck 1.
When recording sound with a recorder component of KENWOOD, synchro recording is possible by setting the INPUT SELECTOR
to select TAPE1 or MD according to the connected component.
Regarding TAPE 2 MONITOR
A cassette deck or graphic equalizer can be connected to this unit’s TAPE 2 MONITOR terminals. If you connect a graphic equalizer, turn the
TAPE 2 MONITOR key ON. If you connect a 3-head cassette deck, you can monitor the source sound, or the sound being recorded, while
recording. Pressing the TAPE 2 MONITOR key lets you compare the recorded sound and the source sound. Refer to the operating manual for
the component you connected for further details.
Preparation
÷Switch the TAPE1 display to MD or VIDEO1 with the following
operation.
1 Select TAPE1 with the INPUT SELECTOR.
2 Press and hold the AUTO key for more than 2 seconds.
Select an input
source other than
TAPE 1.
2 Put the cassette deck in record-pause
mode.
3 Play the source and start recording.
3 VIDEO12 MD1 TAPE1
Each press switches the display.
÷The VIDEO1 display can be switched to the display of other input by
using the procedure described in “Preparation” above.
÷For the synchro recording with a cassette deck and/or MD recorder,
refer to the respective instruction manuals..
÷It is not possible the VIDEO1 or MD input to TAPE1 because all of these
components should use the same INPUT SELECTOR position.
07.6.11, 5:06 PM18