Filter
Top Products
English
|
7
Source function item
Function Setting Entry Setting overview Condition Page
“iPod BY HAND” “ON”/ “OFF”
When set to “ON”, allows you to operate iPod with the
control on the iPod.
14
“RELATED SRCH” —
Starts Related search. 13
“FILE SCAN” “ON”/ “OFF”
When set to “ON”, plays the intro of the music in the
folder successively.
—
“FOLDER RDM” “ON”/ “OFF”
When set to “ON”, plays the music in the folder
randomly.
—
“ALL RANDOM” “ON”/ “OFF”
When set to “ON”, all songs in iPod are played at
random.
14
“FILE REPEAT” “ON”/ “OFF”
When set to “ON”, plays the music repeatedly. —
“FOLDER REP” “ON”/ “OFF”
When set to “ON”, plays the music in the folder
repeatedly.
—
“AUTO MEMORY” —
Memorizes 6 stations with good reception
automatically.
17
“Channel Scan” —
Every receivable Channel is checked for 10 seconds. 28
Preference item
Category Item Setting Entry Setting overview Condition Page
“FAV” —
Enters the Favorite Preset Recall mode. —15
“MENU” “Input Level ADJ” “-8” - “0”
AUX: “-8” - “
+
8”
1 sec.
Adjusts the input level.
16
“SRC Select” “1”*/ “2”
Sets the source selection method. 4
“Skip Search” “0.5%”*/
“1%”/ “5%”/
“10%”
Sets the ratio of skip performed with <Music Search
for iPod>.
12
“Device Regist”* —
1 sec.
Register a Bluetooth device (pairing).
23
“SPCL DVC Select”* —
1 sec.
Allow registration of a special device that cannot be
registered normally.
23
“Phone Selection”* —
1 sec.
Select a cell-phone subject to hands-free connection.
25
“Audio Selection”* —
1 sec. Select the Bluetooth audio player to be connected. —25
“Device Delete”* —
1 sec.
Cancel registration of the Bluetooth device.
25
“BT DVC Status”* —
1 sec. Display the status of the Bluetooth device. — *
“PIN Code Edit”* —
1 sec.
Specify the PIN code required when registering this unit
using the Bluetooth device.
24
“Auto Answer”* “OFF”/ “0S” –
“8S”* – “99S”
Answer a call automatically after lapse of the preset
time interval for automatic answer.
*
“SP Select”* “All”*/ “Left”/
“Right”
Specify the voice output speaker. *
“Call Beep”* “ON”*/ “OFF”
Output a beep from the speaker when a call comes in. *
“Beep Level”* “1” - “5”
Setting the call beep sound volume. ——
“Beep Pattern”* “1” - “4”
Setting the beep sound pattern. ——
“BT F/W Update”* —
1 sec.
Display the firmware version and update the firmware.
25
“Illumi SYNC” “OFF”/ “ON”*
Synchronizes the illumination color of the display with
that of the controller.
5
“Display” “OFF”/ “ON”*
Turns off the display when no operation is performed. — *
*Factory setting
* Function of KOS-A300 with KCA-BT200.
* Refer to <Menu Glossary> (page 31).
Next page 3