Kenwood KIV-700 Home Theater System User Manual


 
English
|
43
Dual Zone System
The separate sources can be selected for Front
channel and Rear channel.
Display Overview
“2Zone Rear Volume”*
1
Adjust the volume of Rear channel.
“0” — “35”
“Detailed Setup”
“2Zone Select”
The Dual Zone System is enabled by selecting
a sub source.
“OFF”/ “USB” (“iPod”/ “Zune”)/ “INT MEM”/
“AUX”
“2Zone Front/Rear”*
1
Specifies the destination of sub source sound
when the Dual Zone function is turned on.
“Rear”/ “Front”
( : Factory setting)
*
1
The Dual Zone System is enabled.
1
Select the source
Press the [SRC] button. Turn the [Volume] knob
and press it when the desired item is displayed.
Select a source other than “STANDBY”.
SRC Select mode 2: Pressing the [SRC] button
repeatedly also switches source.
2
Enter Audio Control mode
Press the [Volume] knob.
3
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “Detailed Setup”.
4
Select the setting item to adjust
Turn the [Volume] knob and press it when the
desired item is displayed.
5
Make a setting
Turn the [Volume] knob to select a setting
value, and then press the [Volume] knob.
6
Exit Audio Control mode
Press the [MENU] button for at least 1 second.
• Select Main source by [SRC] button.
• Adjust the volume of Front channel by [Volume] knob.
• The Audio Control has no effect on sub source.
• “USB”, ”iPod” and “Int.Mem.” (Internal memory) cannot be
set at the same time for the main and sub sources.
• There are following limitations when Dual Zone System
is enabled.
- There is no output from the subwoofer.
- “Fader”, “Subwoofer Level” of <Audio Control> (page 40)
and DSP function are not available.
• The Bluetooth audio source can be set exclusively to the
front speaker. Set “2Zone Front/Rear” to “Rear”.
• The source set as a sub source cannot be operated
during the dual zone mode. Cancel the mode and then
operate the source.