Filter
Top Products
English
|
39
3
Enter Initial Setting mode
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “Initial Settings”.
4
Select the setting item to adjust
Turn the [Volume] knob and press it when the
desired item is displayed.
Display Overview
“Initial Settings”
“Source Select”
Sets the source selection method.
“1”/ “2”
“Beep”
Setting the operation check sound (beep sound)
ON/OFF.
“ON”/ “OFF”
“Menu Language
Select”
You can select the display language for the
Menu list item.
“English”/ “Français”/ “Español”
“Built in AUX”
When this is set to ON, AUX source can be
selected.
“ON”: Allows AUX source to be selected. Use
this setting when the built-in AUX terminal
is connected to the external equipment all
the time.
“OFF”: Disable AUX source selection. Use this
setting when the built-in AUX terminal is
not used.
“Favorite Delete” Deletes Favorite Preset Memory.
Refer to <Favorite Preset Memory Delete>
(page 49).
“Built in AMP”
Selecting “OFF” turns off the built-in amplifier.
Turning off the built-in amplifier improves the
quality of the sound from Preout.
“ON”/ “OFF”
“AV Out Set”
Changes the iPod setting from AV Output to
output-only terminal.
“ON”/ “OFF”
“System F/W
Update”
Updates the firmware. The update information
will be posted on the following URL as
necessary.
www.kenwood.com/cs/ce/
( : Factory setting)
5
Make a setting
Turn the [Volume] knob to select a setting
value, and then press the [Volume] knob.
6
Exit Menu List mode
Press the [MENU] button for at least 1 second,
and then press it again briefly.
Demonstration Mode Setting
Turning the demonstration mode ON/OFF.
1
Enter Menu List mode
Press the [MENU] button.
2
Enter Demonstration mode setting
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “DEMO Mode”.
3
Set the Demonstration mode
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “ON” or “OFF”.
4
Exit Menu List mode
Press the [MENU] button for at least 1 second,
and then press it again briefly.
Function of KIV-700
Muting Volume upon Reception of
Phone Call
The audio system automatically mutes when a call
comes in.
When a call comes in
“CALL” is displayed.
The audio system pauses.
Listening to the audio during a call
Press the [SRC] button.
The “CALL” display disappears and the audio system
comes back ON.
When the call ends
Hang up the phone.
The “CALL” display disappears and the audio system
comes back ON.
⁄
• To use the TEL Mute feature, you need to hook up the MUTE
wire to your telephone using a commercial telephone
accessory. Refer to <Connecting Wires to Terminals> (page
76).