Filter
Top Products
XD-951/A900/A700 (En)
28
Preparation sectionBasic sectionApplication sectionKnowledge sections
Let’s record
1Press the play key corresponding to
the desired direction.
2Stop playback (by pressing the &
key).
To reverse the transport direction
When the equalizer or SRS 3D is applied to the sound, the sound with the applied effect can be recorded . i
When Dolby Pro Logic, Dolby 3 Stereo or DSP mode is selected, cancel it by pressing the STEREO key of the remote control
unit.
Note that this cassette deck cannot record onto Metal tapes.
Note
Note
÷When recording is started, the tape is trans-
ported in the direction selected in this step.
÷Wind the tape to the position where recording
is to be started.
Check the tape transport direction
indicator.
Transport direction
Recording
(Deck B only)
1. Load a tape in deck B.
1Open the door of deck B.
2Insert a tape.
3Close the door.
2. Select the tape transport direction.
3. Set the recording condition.
1Select the reverse mode.
2Select the DOLBY NR mode.
22
11
33
44
55
0
PUSH
OPEN
11
A
3
2
7
22
REV.MODE
DOLBY NR
33
NR
B
0
0
0
0
E
P
A
T
÷Differentiation between normal (TYPE ) and
high (TYPE
) tape is set automatically.
÷Remove tape slack before loading.
(Except for some areas)
÷When the microphone is not used, set the MIC
VOL. control knob fully counterclockwise to
the minimum position.