Filter
Top Products
21
Chapter One : Connecting Your Devices
Connections
Connecting Your CD-R Recorder, continued
Do not plug in the receiver to AC power until you have
connected all your devices.
This section focuses on the connections from your CD-R
recorder to the VR-5700/VR-5090/VR-5080. Please refer to
your CD-R recorder instructions for more detail about its
connection jacks and capabilities.
Each set of instructions in this section shows one of several
possible variations on connecting your CD-R recorder. For
further assistance on optional configurations, contact the
store where you purchased your CD-R recorder.
The VR-5080 is not equipped with the digital input jack for
CD-R recorder.
To Connect a CD-R Recorder:
1. Connect the audio cable from the CD-R recorder’s Play
OUT jacks to the receiver’s CD-R PLAY IN jacks as shown
to the left.
2. Connect the audio cable from the CD-R recorder’s Rec
IN jacks to the receiver’s CD-R REC OUT jacks, as shown
to the left.
3. Connect the digital cable (either optical or coaxial) from
the CD-R’s digital jack to the appropriate digital jack on
the receiver as shown to the left. (The coaxial digital
output jack is available only on the VR-5700/VR-5090.)
The illustration shows two digital connections, one for
coaxial connection and one for optical connection. Your
CD-R recorder supports one or the other of these con-
nection methods—do not connect both.
You only need to connect to the digital output jack if
you will be recording from sources that are connected
to a digital input jack, such as a CD or DVD player.
4. Go to “Noting Your Devices” on page 3 and note which
jacks you used to connect your CD-R recorder. In addi-
tion, note the brand name and model number of the
CD-R recorder.