Kenwood CD-425M Stereo System User Manual


 
6
Connecting to Other Devices
Chapter 1Chapter 2Chapter 3Chapter 4Chapter 5Chapter 6Chapter 7
LR
OUTPUT
DIGITAL OUT
OPTICAL
SYSTEM
CONTROL
RS 232C
SL16
TEXT
TEXT
SYSTEM
CONTROL
OPTICALTEXT
DIGITAL OUT
OPTICAL
TEXT
Connecting to Other Devices
To wall AC
outlet
Receiver or Amplifier, etc.
Digital component (MD,DAT, etc.)
DIGITAL INPUT (OPTICAL)
Optical digital cable
(Commercially-avaliable)
Commu-
nication
cable
System
control
cable
Audio cable
CD
DIGITAL OUT jack (OPTICAL)
Remove the protective cap before using the DIGITAL OUT jack.
DTS Disclaimer clause
When playing DTS-encoded CDs, excessive noise will be ex-
hibited from the analog stereo outputs. To avoid possible
damage to the audio system, the consumer should take proper
precautions when the analog stereo outputs of the CD player
is connected to an amplification system. To enjoy DTS Digital
Surround™ playback, an external 5.1 channel DTS Digital Sur-
round™ decoder system must be connected to the digital out-
put (S/P DIF, AES/EBU, or TosLink) of the CD player.
* 1
Note on the SL16 TEXT jack
When using a KENWOOD Receiver equipped with the SL16 TEXT
jack, connect it to the Receiver using the communication cable
provided with this unit. This makes it possible to display the
disc and track titles on the LCD remote control unit (provided
with the Receiver).
If your receiver has the SL16/XS8 mode select switch,
set the connected receiver to the [SL16] mode.
Note
Note
NotesNotes
Notes
1. Connect all cables firmly. If connections are loose, there could be loss of sound or noise produced.
2. When plugging and unplugging connection cables, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cables without removal of the power cable can cause malfunctions or damage to the unit.
Make connections as shown below.
When connecting the related system components, refer also to the instruction manuals of the related components.
Do not plug in the power lead until all connections are completed.
Remove the cap
Optical digital cable
(Commercially-avaliable)
RS-232C cable “Reverse type”
(Commercially-avaliable)
D-Sub 9 pin connector
*1
Connect a PC to use the
PC LINK function.