Filter
Top Products
6
System connections
LR
OUTPUT
DIGITAL OUT
OPTICAL
SYSTEM
CONTROL
L
R
CD
SYSTEM CONTROL
OPTICAL
DIGITAL OUT
OPTICAL
TEXT
System connections
Make connections as shown below.
When connecting the related system components, refer
also to the instruction manuals of the related components.
Do not plug in the power lead until all connections are com-
pleted.
Be sure to use this unit placed on a level surface.
Malfunction of microcomputer
If operation is not possible or erroneous display appears even though
all connections have been made properly, reset the microcomputer
referring to “In case of difficulty”.
fi
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
DTS Disclaimer clause
When playing DTS-encoded CDs, excessive noise will be exhibited
from the analog stereo outputs. To avoid possible damage to the
audio system, the consumer should take proper pre-cautions when
the analog stereo outputs of the CD player is connected to an am-
plification system. To enjoy DTS Digital Surround™ playback, an
external 5.1 channel DTS Digital Surround™ decoder system must
be connected to the digital output (S/PDIF, AES/EBU, or TosLink) of
the CD player.
To wall AC
outlet
Optical fiber cable
(Commercially-available)
System control cord
Audio cord
Digital amplifier or receiver, etc.
Digital component (MD,DAT, etc.)
Optical fiber cable
(Commercially-available)
Notes
Notes
Remove the pro-
tection cap when
using the DIGITAL
OUT (OPTICAL)
jack.
DIGITAL INPUT
(OPTICAL)