Kenwood KDC-X969 Stereo Receiver User Manual


 
— 51 —
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (for example, the sound may skip).
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
Metal mounting strap
(commercially
available)
Phillips truss head
sheet metal screw
(commercially available)
Firewall or metal support
Screw (M4X8)
(commercially
available)
•To attach this unit, make sure the front of the control panel faces you
and fit it into the mounting sleeve by pressing the four corners of the
hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing the
panel may result.
The hollow at the center of the rubber frame is designed to make it
easier to remove discs.
If you do not want the hollow to be visible, mount the rubber frame in
the opposite direction (with the flat side at the top instead of the
bottom).
Installation (non-Japanese cars)
KDC-X969_U.S_r4.pg 02.12.13 4:45 PM Page 51