Filter
Top Products
Switching the text display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is displayed above the
[3] button.
Refer to <Notes on Multi-function Key System> (page 8).
2 Enter display control mode
Press the [3] ("DISP") button.
3 Enter text select mode
Press the [3] ("TEXT") button.
4 Select the text in the upper text display part
Press the [FM] or [AM] button.
Select the text in the lower text display part
Press the [4] or [¢] button.
Refer to the table described later for setting items.
5 Exit Display Control mode
Press the [RTN] button.
• The setting of this function is available while "Display Type A" is
selected for the Display mode.
• Upper text display part cannot display the same information as
Lower text display part.
• The Album name cannot be displayed during WMA play.
Text Display Switching
Function of the KDC-X969
Switching the Left side graphic Display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is displayed above the
[3] button.
Refer to <Notes on Multi-function Key System> (page 8).
2 Enter display control mode
Press the [3] ("DISP") button.
3 Switch the Left graphic part
Press the [4] ("GRPH") button.
Each time the button is pressed the Left side graphic part
switches as shown below.
Left side graphic part
Source graphic
Spectrum analyzer 1
Spectrum analyzer 2
Spectrum analyzer 3
Spectrum analyzer 4
Spectrum analyzer 5
Spectrum analyzer 6
Spectrum analyzer 7
Blank
4 Exit display control mode
Press the [RTN] button.
If <Dual Zone System> (page 26) is turned ON while the spectrum
analyzer is displayed, the left side graphic display automatically
displays the source graphic.
Left Side Graphic Display Switching
General features
— 20 —
English
KDC-X969_U.S_r4.pg 02.12.13 4:44 PM Page 20