Kenwood KDC-X969 Stereo Receiver User Manual


 
Graphic display
Demonstration
Spectrum analyzer 1
Spectrum analyzer 2
Spectrum analyzer 3
Spectrum analyzer 4
Spectrum analyzer 5
Graphic
Function of the KDC-X869/KDC-MP922
Switching the graphic Display/ Spectrum analyzer & Text display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is displayed above the
[3] button.
Refer to <Notes on Multi-function Key System> (page 8).
2 Enter display control mode
Press the [3] ("DISP") button.
3 Select the graphic display
Press the [3] ("SA") button.
Refer to the table described later for setting items.
Select the Spectrum analyzer & Text display part display
(Only when Display Type is "Display Type C")
Press the [4] or [¢] button.
Refer to the table described later for setting items.
4 Exit display control mode
Press the [RTN] button.
The setting of this function is available while "Display Type B" or
"Display Type C" is selected for the Display mode.
Graphic part/ Spectrum Analyzer & Text Display
Switching
Function of the KDC-X969
Select a wallpaper to display when Display Type is set to
"Display Type B" or "Display Type C".
1 Select the wallpaper display
Refer to <Right Side Graphic Display Switching> (page 17).
2 Select the wallpaper
Display the wallpapers one after another and select one
1 Turn the wallpaper scan ON
Press the [38] button.
Each time the button is pressed the Wallpaper scan is turned
ON and OFF.
When it's ON, "SCAN" is displayed.
When it’s ON, each wallpaper is displayed every several
seconds.
2 At the wallpaper you want to display
Press the [38] button.
Select wallpaper manually
1 Turn the wallpaper scan OFF.
Press the [38] button.
Each time the button is pressed the Wallpaper scan is turned
ON and OFF.
2 Select the wallpaper.
Press the [4] or [¢] button.
Each time the button is pressed the wallpaper changes.
3 Exit Display Control mode
Press the [RTN] button.
Wallpaper selecting
General features
— 18 —
English
KDC-X969_U.S_r4.pg 02.12.13 4:44 PM Page 18