Filter
Top Products
42
|
English
Connecting Wires to Terminals
ANT.
CONT
MUTE
P.CONT
FRONT • L
FRONT • R
REAR • L
REAR • R
–
+
FRONT
SUB
WOOFER
AUX IN
REAR
FM/AM antenna input
Front left output (White)
Front right output (Red)
Fuse (10A)
Wiring harness
(Accessory1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left speaker
To front right speaker
To rear right speaker
To rear left speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
Ignition key
switch
Car fuse box
(Main fuse)
ACC
Car fuse
box
Battery
If no connections are made, do not let the wire come out from the tab.
Rear left output (White)
Rear right output (Red)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
When using the optional power amplifier, connect to its power
control terminal.
To car light control switch
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal
for the booster amplifier of the film-type antenna.
AUX left input (White)
AUX right input (Red)
External amplifier control wire
(Pink/Black)
To "EXT.AMP.CONT." terminal of the amplifier having the external
amp control function.
Sub Woofer left output (White)
Sub Woofer right output (Red)
To connect the Kenwood navigation system, consult your
navigation manual.
TEL mute wire (Brown)
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
To connect these leads, refer to the relevant
instruction manuals.
To Kenwood disc changer/ External optional accessory
USB connector
Do not remove the cap when you do not
use the USB cable. The connector will
cause the unit to malfunction if it gets in
touch with any metallic part of the vehicle.
To USB device