Filter
Top Products
English
|
17
"Display Type D"
4 7
6
8 8 8 8 8 8
1 Graphic display part
2 Text display part
3 Text icon display part
4 Upper text display part
5 Middle text display part
6 Lower text display part
7 Source icon display part
8 Function item display
5 Exit display control mode
Press the [6] ("RTN") button.
• Under the display type other than "Display Type D",
the function item is not displayed. When you select
the display type other than "Display Type D", press [1]
to [6] buttons or [NEXT] button. The function item will
be displayed approximately for 5 seconds.
• The indicator is displayed when the display type is set
to "Display Type C" or "Display Type D".
• To change the information by the Display Type, refer
to the page on the following table for the methods to
alternate by the Display Type.
Display Type
ABC D
Graphic 1
17 17
——
Text 2
—
18
——
Upper 4
——
20 20
Middle 5
——
20
—
Lower 6
——
21 21
Display Type A/ Display Type B
Graphic part/ Spectrum Analyzer
Display Switching
Changing the graphic Display/ Spectrum analyzer
display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [2] button.
Refer to <Notes on Multi-function Key System>
(page 10).
2 Enter display control mode
Press the [2] ("DISP") button.
3 Select the display mode
Press the [1] ("MODE") button.
4 Select the display Type
Push the Control knob towards [4] or
[¢].
Select the "Display Type A"/ "Display Type B"
display.
5 Select the graphic/ spectrum analyzer
display
Press the [3] ("Graph") button.
6 Select the graphic/ spectrum analyzer
display part display
Push the Control knob towards [4] or
[¢].
Each time you push the knob, the graphic
display/ spectrum analyzer display alternates
between the displays shown in the table below.
Graphic display/ Spectrum Analyzer display
Movie 1
Movie 2
Spectrum analyzer 1
Spectrum analyzer 2
Spectrum analyzer 3
Wallpaper
7 Exit display control mode
Press the [6] ("RTN") button.
• The setting of this function is available while "Display
Type A"/ "Display Type B" is selected for the Display
mode.