Filter
Top Products
English
— 44 —
Removing the Unit
Removing the hard rubber frame
■
Insert the removal tool into the indentations in the hard rubber
frame, and pull it gently until the lock is released.
Accessory0
Removal tool
Removing the Unit
■
L
Push upward the both
tools, as shown, and pull
the unit toward you until it
is halfway out. The unit
may drop if you pull it out
completely.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
6
L
Make the faceplate control panel appear.
Refer to the section “Removing the hard rubber frame” and
then remove the hard rubber frame.
Remove the hex head machine screw with washer (M4×8) on
the back panel.
Insert the removal tool deeply, as illustrated, with the L on the
left and the R on the right.
4
3
2
1
If the unit is removed while
the faceplate is closed, use
the removal tool with the left
and right reversed, as
illustrated.
NOTE
R
L
Accessory4
Accessory3
Removal tool
KDC-X715_U.S_r9 00.12.26 3:48 PM Page 44