Filter
Top Products
English
— 42 —
Connecting Wires to Terminals
ANT.
CONT.
ILLUMI
EXT.CONT.
P.CONT
+
+
+
+
FRONT • L
FRONT • R
REAR • L
REAR • R
–
+
FRONTREAR
When only two speakers are being connected to the
system, connect the connectors either to both the
front output terminals or to both the rear output
terminals (do not mix front and rear). For example, if
you connect the + connector of the left speaker to a
front output terminal, do not connect the - connector
to a rear output terminal.
2CAUTION
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
2WARNING
FM/AM antenna input
Rear right output (Red)
Fuse (10A)
KENWOOD disc changer
/ DAB control input /
Wiring harness
(Accessory1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left
speaker
To front right
speaker
To rear right
speaker
To rear left
speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Ignition key
switch
Car fuse
box
(Main fuse)
ACC
Car fuse box
Battery
If no connections are made, do not let the wire come out from the tab.
Front left output (White)
Front right output (Red)
/Non-fading right output
(KDC-X715 only)
To connect the Disc changer or
DAB unit, consult each manual.
NOTE
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
When using the optional power amplifier, connect
to its power control terminal.
To car light control switch
External amplifier control wire
(Pink / Black) (KDC-X715 only)
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
Display Data Output Jack
Outputs data representing
the unit's current state,
causing it to appear in the
external display.To
connect to this jack, a
converting adapter
(optional) is necessary.
(KDC-X715/8015 only)
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
film-type antenna.
/Non-fading left output
(White) (KDC-X715 only)
Rear left output (White)
KDC-X715_U.S_r9 00.12.26 3:48 PM Page 42