Kenwood KDC-X815 CD Player User Manual


 
47
L
T
N
T
N
R
TN
T
N
Installing Radio Bracket in Japanese-made Cars (J-Cars)
On the factory-installed radio bracket, flatten all
the tabs or holes that are not flush (except
those used for screws), using a hammer or
similar utensil.
8mm
5mm
5mm
8mm
After aligning the J-Car bracket
with the factory-installed radio
bracket, tighten the screws.
Damage to the unit will result
from using screws other than
those provided.
2CAUTION
Accessory6
for Toyota car
Accessory5
for Nissan car
Tab
Hole
Once you have affixed the factory-installed radio bracket
with the screws, use a standard-tipped screwdriver (not
Philips) or similar utensil to pry the tabs of the J-Car
bracket to make them fit into the holes in the factory-
installed radio bracket (depending on the car make).
Tab
N Nissan car
T Toyota car
Factory trim bezel
Accessory8
J-Car Bracket
(follow indications for L/R)
Accessory9
J-Car Trim Plate
(place thick part on
bottom)
Factory-installed
Radio Bracket
Factory-installed
Radio Bracket
Installation (Japanese-cars)
KDC-X915_U.S_r4 00.12.26 3:53 PM Page 47