Kenwood KDC-116S CD Player User Manual


 
English
26
Connecting Wires to Terminals
+
+
+
+
+
FRONT L
FRONT R
REAR L
REAR R
P.CONT
ANT
CONT
FRONT
When only two speakers are being connected to the system, connect the
connectors either to both the front output terminals or to both the rear
output terminals (do not mix front and rear). For example, if you connect
the + connector of the left speaker to a front output terminal, do not
connect the - connector to a rear output terminal.
2CAUTION
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may cause
a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
2WARNING
FM/AM antenna input
Rear left output (White)
Rear right output (Red)
Fuse (10A)
KENWOOD disc changer control input
(KDC-416S/316S/37MR/316V only)
Wiring harness
(Accessory1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left
speaker
To front right
speaker
To rear right
speaker
To rear left
speaker
Power control/
Motor antenna control wire
(Blue/White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
Ignition key
switch
Car fuse box
(Main fuse)
ACC
Car fuse box
Battery
If no connections are made, do not let the
wire come out from the tab.
Connect either to the power control
terminal when using the optional
power amplifier, or to the antenna
control terminal in the vehicle.
Front left output (White)
(KDC-416S/316S only)
Front right output (Red)
(KDC-416S/316S only)
To connect the Disc changer,
consult your Disc changer manual.
NOTE
KDC-416S(K)_U.S_ver2.0 00.12.26 0:58 PM Page 26