Filter
Top Products
— 45 —
Removing the Unit
•To attach this unit, make sure the front of the control panel faces you
and fit it into the mounting sleeve by pressing the four corners of the
hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing the
panel may result.
• The hollow at the center of the rubber frame is designed to make it
easier to remove discs.
If you do not want the hollow to be visible, mount the rubber frame in
the opposite direction (with the flat side at the top instead of the
bottom).
Catch
Lock
Accessory2
Removal tool
■ Removing the hard rubber frame
2 When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
1 Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
KDC-M7024_U.S_r2 03.1.15 10:12 AM Page 45