Filter
Top Products
3rd section
[2] button
Adjustment Item Display Range
Volume offset "V-Offset" –8 — ±0
Volume offset: Each source's volume can be set as a difference
from the basic volume.
[3] button
Adjustment Item Display Range
Non-Fading "LPF NF" 50/80/120/Through Hz
Low Pass Filter
[4] button
Adjustment Item Display Range
Loudness "LOUD" ON/OFF
[5] button
Adjustment Item Display Range
Non-Fading level "NF Level" –15 — +15
• Loudness: Compensating for low and high tones during low
volume.
• When the Dual Zone System is ON, the setting for the High Pass
Filter is nullified.
2nd section
[2] button
Adjustment Item Display Range
Front/Rear "HPF"
High Pass Filter
Through/100/125/170 Hz
[3] button
Adjustment Item Display Range
Middle Center
Frequency
"MID F" 0.5/1.0/1.5/2.0 kHz
Middle level "Middle" –8 — +8
Middle Q Factor "Middle Q" 1.0/2.0
[4] button
Adjustment Item Display Range
Treble Center
Frequency
"TRE F" 10.0/12.5/15.0/17.5 kHz
Treble level "Treble" –8 — +8
[5] button
Adjustment Item Display Range
Balance "Balance" Left 15 — Right 15
Fader "Fader" Rear 15 — Front 15
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the bass extend is set to ON, low frequency response is
extended by 20%.
— 13 —
KDC-M7024_U.S_r2 03.1.15 10:10 AM Page 13