Filter
Top Products
16
EN
ENGLISH
Clock/timer operation
Timer setting
The system can switch on to CD, TUNER or TAPE
mode automatically at a preset time, serving as
an alarm to wake you up.
The timer recording of radio programs onto a cas-
sette tape is also possible.
Important!
Before setting the timer, ensure that the clock
is set correctly.
When setting the timer (playback or record-
ing) for TUNER, be sure to select the station
you wish to tune in beforehand.
1 Turn the system on.
2 Press timer set button (TIMER SET button on
the remote control) twice to enter timer set-
ting mode.
The icon “TIMER ON” will start flashing on the
display.
3 Press program button (PROGRAM button on
the remote control).
The hour indication will start flashing.
4 Set the time to start playback.
Press 4 or ¢ button (4 or ¢ SEARCH/
SKIP/TUNING button on the remote control)
to set timer start hours and press program
button (PROGRAM button on the remote con-
trol) to store the setting.
Repeat the same procedure to set the minutes.
5 Press timer set button (TIMER SET button
on the remote control).
The icon “TIMER OFF” will start flashing.
6 Repeat the step 3 and 4 to set the time to
stop the timer (off time).
7 Press timer set button (TIMER SET button on
the remote control).
The icon “TIMER” will flash and the source
display will appear.
View clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode (CD, TUNER
or TAPE), press timer set button (TIMER SET
button on the remote control). The clock will be
displayed.
If the clock has not been set, “0:00” will start flash-
ing.
Clock setting
Before carrying out the clock setting, ensure
that the system is in standby mode.
1 Press program button (PROGRAM button on
the remote control) to enter the hour setting
mode.
The hour indication will start flashing.
2 Press 4 or ¢ button (4 or ¢ SEARCH/
SKIP/TUNING button on the remote control)
to set the hours.
3 Press program button (PROGRAM button on
the remote control) to enter the minute set-
ting mode.
The minute indication will start flashing.
4 Press 4 or ¢ button (4 or ¢ SEARCH/
SKIP/TUNING button on the remote control)
to set the minutes.
5 Press program button (PROGRAM button on
the remote control) to store the setting.
The clock will start working.
To exit without storing the setting, turn on the
system.
Notes:
•The clock setting will be erased when the power
cord is disconnected or a power failure occurred.
•The clock can be set in either 12 or 24-hour mode.
To change the mode : When the system is in standby
mode, press TUNER/band button while pressing
6 PLAY/PAUSE button.
04.6.30, 3:22 PM16