Filter
Top Products
English
|
17
Audio Adjustments
Cabin selection
You can compensate the delay of the sound arrival
time, which is caused by the installation position of
the speakers, by selecting your environment from
the following car types;
Car type (rear speaker position) Display
Not compensating. “OFF”
Compact car (rear door) “Compact1”
Compact car (cargo) “Compact2”
Full size car (rear door) “Full Size Car1”
Full size car (cargo) “Full Size Car2”
Station wagon (rear door) “Wagon1”
Station wagon (cargo) “Wagon2”
Minivan (rear door) “Minivan1”
Minivan (cargo) “Minivan2”
Sport-utility vehicle (rear door) “SUV1”
Sport-utility vehicle (cargo) “SUV2”
Minivan Long (rear door) “Minivan(Long)1”
Minivan Long (cargo) “Minivan(Long)2”
Calls the value adjusted at <DTA> (page 17). “User”
1 Enter Cabin select mode
Select “SOUND” > “S-SET” > “CABIN”.
For how to select Function Control item, refer to
<Function Control> (page 6).
2 Select the car type
Turn the Control knob.
3 Exit Cabin select mode
Press the [FNC] button.
⁄
• You can compensate the distances in more details by
using <DTA> (page 17) function.
In addition, the value specified at <DTA> can be called
by selecting “User”.
2 Select the speaker you want to set
Setting speaker Display
Front speaker “DTA-Front”
Rear speaker “DTA-Rear"
Subwoofer “DTA-Sub"
Turn the Control knob and push the center
when the desired item is displayed.
3 Set the compensation value of the speaker
position
Turn the Control knob.
Adjust between 0 and 440 cm.
Refer to <Appendix> (page 25) on how to set the
compensation value.
4 Exit DTA setting mode
Press the [FNC] button.
X’Over setting
You can set a X’Over value for the speakers;
Adjustment Item Display Range
Front High Pass Filter “HPF-Front” Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter “HPF-Rear” Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter “LPF” 50/60/80/100/120/Through
Hz
Subwoofer level “SUB-W LEVEL” –15 — +15
Subwoofer Phase “SW PHASE” Reverse (180°)/ Normal (0°)
1 Enter X’Over setting mode
Select “SOUND” > “S-SET” > “XOVER”.
For how to select Function Control item, refer to
<Function Control> (page 6).
2 Select the item you want to set
Turn the Control knob and push the center
when the desired item is displayed.
3 Set the X’Over value
Turn the Control knob.
4 Exit X’Over setting mode
Press the [FNC] button.
DTA (Digital Time Alignment) setting
Adjusting fine tuning of the speaker position
compensation value specified at <Cabin selection>
(page 17).
1 Enter DTA setting mode
Select “SOUND” > “S-SET” > “DTA”.
For how to select Function Control item, refer to
<Function Control> (page 6).