Filter
Top Products
— 31 —
Press the 38 button.
The security code will be set.
"CODE ✽✽✽✽1" appears in the display, asking you to enter the
code once again for confirmation, and then you can start
inputting the code.
Press the Preset button and input the security code again.
Press the 38 button again.
"CODE WRITE" will appear in the display, with the security code
function turning on. From this point on, if the unit is
disconnected from the battery, the security code must be
entered the first time that the unit's power is turned on. "CODE
✽✽✽✽" will appear in the display, asking you to input the code.
If you input an incorrect security code, the display ask you once
more to input the correct one. Follow the procedure in step 6
above.
If you press the RESET button or remove the battery:
The first time you turn the unit on again, "CODE ✽✽✽✽" will
appear in the display, asking you to input the security code.
Repeat steps 8 and 9 above, and input the security code.
You can start operating the unit again when "CODE OK!"
appears in the display.
If you enter the incorrect code, the power will turn off,
displaying "CODE NG!". Enter the correct code to turn the unit
on.
NOTE
9
8
7
Step Button to press
# Times
pressed
Display
1
#1 4
3
6#2
2
#3 2
4
#4 1
“3”
“5”
“1”
“0”
When the battery is removed from the unit's power switch, you
cannot turn on the unit again unless the preset security code is
input. This function helps prevent theft.
You must follow steps 1 to 9 to be able to use the Security Code
function. Turning off the power during the procedure will
deactivate the security code setting.
Once the security code function has been activated, "CODE
STBY" disappears from the function set system. Note that it will
no longer be possible to cancel this function afterwards.
Select the four digits to use in your security code.
The four-digit security code is very important, as you will need it
to turn the unit on again when the code security function is on.
Choose the number carefully and do not forget it (write it down
and keep it separately in a safe place).
Press the SRC button repeatedly and switch the display to "ALL
OFF" to enter the standby mode.
Press the FNC button.
"Function Set" is displayed and the function set mode is turned
on.
Keep pressing the ¢ button until the “CODE STBY” appears
in the display.
Press the 4 button to search in the other direction.
Press either the AM or FM button for at least two seconds.
"CODE WRITE" will appear in the display for one second,
indicating the code setting mode has been entered. When
"CODE ✽✽✽✽" appears in the display, you can start inputting
the code.
Press the preset button and enter the security code that you
have selected in step 1.
Example: Use "3510" as the security code.
6
5
4
3
2
NOTE
1
NOTE
6. Security Code
DPX-6020_K_U.S 01.12.25 1:57 PM Page 31