Kenwood CT/KXF-W Cassette Player User Manual


 
CT-2050/203/KXF-W6010/W4010 (En/M)
12
Listening to cassette tape
÷Tapes are played in the directions indicated by their respective indicators
on the display.
÷The playback starts with the deck the play key of which is pressed.
1
Load cassette tapes in both decks.
Relay playback
This function plays back the tapes in both decks A and B
continuously and repeatedly.
Press stop (7) key of the deck that is
playing.
Each press switches the indication.
1 [ : Relay playback of two sides of tapes in decks A and
B is repeated.
2 ”: Relay playback is not available with this setting.
3 ” : Relay playback of only one side of tapes in decks A
and B is repeated.
Each press switches the indication.
1 DOLBY NR “OFF” (extinguished): Dolby NR is not used.
2 DOLBY NR “B”: Noise reduction of the ordinary type.
3 DOLBY NR “C”: Noise reduction with higher performance.
÷Select the Dolby NR mode according to the tape recording status.
To Stop relay playback
: Keys and control used in the operations described on this page.
Deck B: Play-
back/recording
available.
BA
Deck A:
Playback only. (CT-203/
KXF-W4010 only)
Playback/recording avail-
able. (CT-2050/KXF-W6010
only)
0
1
Open the cassette holders of decks A and
B.
2
Insert cassette tapes and close the cas-
sette holders of decks A and B.
2
Determine the playback condition.
3
Start playback.
÷Be sure to remove tape slack before insertion.
÷Be sure to close the cassette holder securely by pushing it.
REV.MODE
DOLBY NR
1
Select the playback (recording) mode.
2
Select the Dolby NR mode.
237
237