Filter
Top Products
Page - 11
EMCEE WAS WORKING THE LAST TIME I USED IT, BUT NOW THE CONTROLLER IS NOT RESPONDING?
If you have been using eMCee succesfully but are now having communica-
tion problems, you should try discarding eMCee’s preferences.
For Macintosh users: open your System Folder, open the Preferences folder
and locate eMCee’s preference file, discard the file.
For PC users: the preference file for eMCee is in the same folder as the ap-
plication, discard the file. Once you have discarded the preferences, you will
need to restore the preferences for your specific Kaidan model.
I HAVE DONE EVERTYTHING BUT EMCEE CANNOT SEE THE CONTROLLER?
If you have read through this appendix and have not a solution to your prob-
lem, please email: support@kaidan.com or call 215-364-1778 Mon-Fri 9am to 6pm
EST.
Sincerely,
The Kaidan Support Team
M-2500M-2500
M-2500M-2500
M-2500 X-Axis Y-Axis
Steps per Rev 20000 20000
Intial Velocity 100 100
Slew Velocity 500 300
Ramp Slope 10 10
Move Speeds 500 300
Step Resolution Full
MDT-19MDT-19
MDT-19MDT-19
MDT-19 X-Axis Y-Axis
Steps per Rev 14165* 0
Intial Velocity 100 0
Slew Velocity 300 0
Ramp Slope 15 0
Move Speeds 300 0
Step Resolution Full 0
*Note - This value has been calibrated specifi-*Note - This value has been calibrated specifi-
*Note - This value has been calibrated specifi-*Note - This value has been calibrated specifi-
*Note - This value has been calibrated specifi-
cally for your unit, you will find this value oncally for your unit, you will find this value on
cally for your unit, you will find this value oncally for your unit, you will find this value on
cally for your unit, you will find this value on
the underside of the unit.the underside of the unit.
the underside of the unit.the underside of the unit.
the underside of the unit.