JVC XV-THA55 Home Theater System User Manual


 
Getting started
18
For VCR operations
You can operate your VCR using the remote control supplied with
this system.
Refer also to the instruction manuals supplied with your VCR.
7 To set the manufacturer’s code
1 Slide the remote control mode selector
to VCR.
2 Press and hold F VCR.
Keep the button pressed until step 4 is finished.
3 Press ENTER.
4 Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).
Examples:
For a Panasonic VCR: Press 2, then 1.
For a Philips VCR: Press 0, then 5.
5 Release F VCR.
6 Try operating your VCR by pressing
F VCR.
When your VCR turns on or off, you have entered the correct
code.
If there is more than one cord listed for your brand, try each
one until you enter the correct one.
NOTE
Manufacturers’ codes are subject to change without notice. If they are
changed, this remote control cannot operate the equipment.
Set the codes again after replacing the batteries of the remote control.
7 Operation
IMPORTANT
Before using the remote control to operate a VCR;
Set the remote control mode selector to VCR.
The following buttons are available:
F VCR: Turns VCR on and off.
3 (play button): Starts playback.
7 : Stops operation.
8 : Pauses playback.
¢: Fast forwards video tape.
4: Rewinds video tape.
REC: Press this button together with 3 (play button) to
start recording or together with 8 to pause
recording.
CHANNEL +/–: Changes the TV channels on the VCR.
Manufac-
turer
Code
Manufac-
turer
Code
JVC 01 Nokia 16
Aiwa 02, 20 Nordmende 17 – 19, 31
Bell+Howell 03, 16 Orion 20
Blaupunkt 04 Panasonic 21
CGM 03, 05, 16 Philips 05, 22
Daewoo 34 Phonola 05
Digtal 05 Saba 17 – 19, 23, 31
Fisher 03, 16 Samsung 24, 25
G.E. 06 Sanyo 03, 16
Grundig 07 Sharp 26, 27
Hitachi 08, 09 Siemens 07
Loewe 05, 10, 11 Sony 28 – 30, 35
Magnavox 04, 05 Telefunken 17 – 19, 31, 32
Mitsubishi 12 – 15 Toshiba 33
TH-A85-55[B]-04Start.fm Page 18 Thursday, April 10, 2003 3:58 PM