Filter
Top Products
Page 3
English
BEFORE USING FOR THE FIRST TIME
Putting batteries in the remote control
The battery compartment is located on the back of the remote control.
1. Insert your finger in the recess under the battery compartment
cover, and pull off the cover.
Installing batteries
2. Place the two accessory R6P (SUM-3)/AA (15F) batteries in the
remote control according to the polarity markings (“+” and
“–”) inside the compartment and on the batteries.
3. Insert the two tabs of the cover in their respective slots, and
snap the cover in place.
The batteries last about one year with normal use. If function of the
remote control become erratic, replace the batteries.
Precautions for the safe use of batteries
Observe the following precautions for the safe use of batteries. Their
life will be shortened, they may burst or their contents may leak if they
are used improperly.
Connecting the power cord
Connecting the AV COMPU LINK cable
Connect with other JVC equipment supporting the AV Compulink by
using the supplied AV COMPU LINK cable to facilitate operations.
See “AV COMPU LINK remote control system” on page 25.
After the audio-video connectors had been connected, insert the
female end of the power cord firmly into the AC POWER CORD socket
located on the rear panel of the player. Then insert the male end of the
power cord into the wall outlet.
When the power cord is connected and the POWER ON/OFF button
is depressed (ON), the STANDBY indicator on the left-hand side of the
player’s front panel comes on. See “Overview of Controls” for a
description of the controls on the player.
IMPORTANT
Check the setting of the VOLTAGE SELECTOR switch on the rear
panel of the player.
Change the setting if the switch is not set for the main voltage
supplied to your home.
To AV COMPU LINK jack
of another JVC equipment
AV COMPU LINK cable
Wall outlet
AC power cord
EN.01-27.XL-MV7000GD[U,US] 99.11.15, 3:48 PM3