Filter
Top Products
– 7 –
English
RIGHT LEFT
MAIN
SPEAKERS
SPEAKER
IMPEDANCE
MIN
6
RIGHT LEFT
MAIN
SPEAKERS
SPEAKER
IMPEDANCE
MIN
4
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
• If the AM loop antenna wire is covered with
vinyl, remove the vinyl by twisting it as
shown in the diagram.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
loop antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM antenna
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
Connecting Speakers
Right
speaker
Left
speaker
Black
Red
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
Speaker
cord
Speaker
cord
1
2
AM EXT
FM
COAXIAL
AM LOOP
75
ANTENNA
]
]
1
2
Red
Black
Speaker
cord
Speaker
cord
For UX-P3
For UX-P5
3
EN01-13.UX-P5&3[[UW,UY] 01.2.26, 11:01 AM7