Filter
Top Products
4
English
CAUTION: Make all connections before plugging the System into an AC power outlet.
1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords between the Speaker terminals of the Unit and the terminals of the Speakers.
Connect the cords with a black line to the (–) terminals and cords without a black line to the (+) terminals.
3. Close each of the terminals to securely connect the cords.
Right speaker (rear side) Left speaker (rear side)
CAUTION: A TV may display irregular colors if located near the speakers. If this happens, set the speak-
ers away from the TV.
Removing the speaker grilles
The speaker grilles can be removed.
When removing, Attaching the speaker grille
1. Insert your fingers at the top and pull towards you.
2. Also pull the bottom towards you.
Connecting a Tape Deck, etc.
Connect (not supplied) signal cords between the System's LINE IN (AUX1)/OUT terminals and the output/input terminals of the external tape
deck, etc.
You can listen to one of these sources. Also, you can record the System's CD Player, MD Player, or tuner output signal to the external tape deck,
etc.
.
Connecting the Speakers
Connecting External Equipment
Speaker cord
SPEAKERS
IMPEDANCE
MIN 4
R
L
Marked with a black line
SPEAKER CORD
Speaker grille
R
L
LINE IN
(AUX1)
LINE OUT
Signal cord (not supplied)
Tape deck, etc. (not supplied)
Pin-plug x 2
Pin-plug x 2
Pin-plug x 2
Pin-plug x 2
Signal cord (Not supplied)
Ux-MD9000-e.fm Page 4 Tuesday, June 23, 1998 9:38 AM