Filter
Top Products
5
!
Digital audio component
• Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu
correctly according to the connected digital audio
equipment (see page 35). If setting is incorrect, loud noise
may be generated causing damage to the speakers.
⁄
To connect the powered subwoofer
@
Speakers
• When connecting the speaker cords, match the polarity of
the speaker terminals: red color to (+) and black color to (–).
Before plugging in the System
Set the correct voltage for your area with the voltage selector
on the rear.
Use a screwdriver to set the voltage selector to the same
voltage as where you are plugging in the unit. (See also the
back cover page.)
Preparing the remote control
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
When using the remote control
Point the top of the remote control toward the remote sensor
as directly as possible. If you operate it from a diagonal
position, the operating range (approx. 5 m) may be shorter.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
DVD OPTICAL
DIGITAL OUT
PCM
/
STREAM
Protective cap
SUB-
WOOFER
OUT
From the powered
subwoofer
(not supplied)
From right
speaker
From left
speaker
Red
Black
When connecting auxiliary equipment (AUX)
DO NOT recharge, short, disassemble or
heat the battery or dispose of it in a fire.
Stereo mini plug
(not supplied)
110V
VOLTAGE
SELECTOR
127V
220V-
230V
R6(SUM-3)/AA(15F)
UX-GD6[US].book Page 5 Tuesday, March 8,2005 5:03 PM