Filter
Top Products
13
Playing Back from the PC
This System is equipped with a USB terminal on the front
panel of the main unit. You can connect your PC to this
terminal and enjoy sound reproduced through your PC.
When you connect your PC for the first time, follow the
procedure below.
• Remember you cannot send any signal or data to your PC
from this System.
How to install the USB drivers
1
Turn on your PC and start running Windows
R
98,
Windows
R
98SE, Windows
R
Me, Windows
R
2000, or
Windows
R
XP.
• If the PC has been turned on, quit all the applications
now running.
2 Select USB as the source.
3 Set the volume to minimum.
4 Connect the System to the PC using a USB cable (not
supplied).
•
Use “USB series A plug to B plug” cable when
connecting.
5 The USB drivers are installed automatically.
To play back sounds on the PC
Press USB, then start playback from PC.
Refer to the manuals supplied with the sound reproduction
application installed in the PC.
*Microsoft
R
, Windows
R
98, Windows
R
98SE, Windows
R
Me, Windows
R
2000 and Windows
R
XP are registered
trademarks of Microsoft corporation.
memo
• DO NOT turn off the unit or disconnect the USB cable
while installing the drivers and for several seconds while
your PC is recognizing the receiver.
• Use a full speed USB cable (version 1.1). Recommended
cord length is shorter than approximately 2 m.
• If your PC does not recognize the unit, disconnect the USB
cable and connect it again. If it does not work yet, restart
Windows.
• The installed drivers can be recognized only when the USB
cable is connected between the unit and your PC.
• The sound may not be played back correctly—interrupted
or degraded—due to your PC settings and PC
specifications.
IMPORTANT
• Always set volume to “VOL-MIN” when connecting or
disconnecting the other equipment.
USB cable
PC
(front panel)
UX-G50[J].BOOK Page 13 Sunday, April 23, 2006 7:42 PM