Filter
Top Products
– 31 –
English
REC
Timer mode
REC indicator
Timer indicator
When you unplug the AC power cord or if a power
failure occurs
The clock setting will be reset to “0:00.” If this happen, you need to
set the clock again.
Using Recording Timer
With Recording Timer, you can make an unattended
recording.
• You can set Recording Timer whether the unit is turned
on or off (on standby.)
• To correct a misentry any time during the setting process,
press CANCEL.
How Recording Timer actually works
The unit automatically turns on, and starts recording on a
tape when the timer-on time comes. (While Recording
Timer is working, the REC indicator keeps flashing.) Then,
when the timer-off time comes, the recording stops and the
unit automatically turns off (on standby.)
Recording Timer works only once, but the timer settings
remain stored in memory unless you reset them or unplug
the AC power cord.
On the remote control ONLY:
1
Press CLOCK/TIMER repeatedly until “REC
TIMER” appears on the display.
The timer (
) indicator lights, and the REC indicator
starts flashing on the display.
• Each time you press the button, the timer mode
changes as follows:
There are three timers available—Recording Timer, Daily
Timer, and Sleep Timer.
You need to set the built-in clock to use these timers.
Setting the Clock
You can set the clock whether the unit is turned on or off
(on standby.)
On the remote control ONLY:
1
Press CLOCK/TIMER repeatedly until “TIME
ADJUST” appears on the display.
The hour digit starts flashing on the display.
2
Press ¢ or 4 repeatedly to adjust the hour.
• When you press and hold the button, the hour digit
changes continuously.
3
Press SET to set the hour.
The minute digit starts flashing on the display.
• If you want to correct the hour again, press
CANCEL.
The hour digit starts flashing again.
4
Press ¢ or 4 repeatedly to adjust the minute.
• When you press and hold the button, the minute digit
changes continuously.
5
Press SET to finish setting the clock.
The built-in clock starts.
To adjust the clock again
Press CLOCK/TIMER repeatedly in step
1
until “TIME ADJUST”
appears on the display, then perform steps
2
to
5
above.
To check the clock time by sound while the unit is
turned off (on standby)
Press DIMMER while the key-touch tone is set to on. The clock
time will be indicated by sound.
REC TIMER DAILY TIMER
TIME ADJUST
Canceled
Ex. When pressing SET after
adjusting the minute to 10.
Ex. When pressing SET after
adjusting the hour to 10.
EN30-34UX-A52[UW]_f 01.12.18, 2:20 PM31