Filter
Top Products
– 9 –
English
R
SPEAKER IMPEDANCE
L
MIN 4
RL
AC IN
230V
VOLTAGE
SELECTOR
127V
110V
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and the LINE IN (AUX) jacks by using an audio
cord (not supplied.)
To output
Analog audio
equipment
LINE IN
(AUX)
To connect analog audio equipment
Be sure that the plugs of the audio cords and the jacks on
the rear of the unit are color-coded: White plugs and jacks
are for left audio signals, and red ones for right audio
signals.
NOW, you can plug the AC power cord.
• If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
IMPORTANT: Be sure to check all connections to be done
before plugging the AC power cord into a wall outlet.
When connecting the AC power cord into a wall outlet, the
unit automatically starts the display illumination.
To stop and cancel the display demonstration, press
COLOR during display illumination—while the unit is
turned off (on standby.)
To start the display illumination manually, press
COLOR again while the unit is turned off (on standby.)
R
SPEAKER IMPEDANCE
L
MIN 4
AC IN
230V
VOLTAGE
SELECTOR
127V
110V
1
To the AC IN terminal
AC power cord
(supplied)
2
To a wall outlet
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to rotate the voltage selector so the
voltage number the voltage arrow is pointing at is the same
as the voltage where you are plugging in the unit. (See
back cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection procedures
are complete.
R
SPEAKER IMPEDANCE
L
MIN 4
AC IN
230V
VOLTAGE
SELECTOR
127V
110V
230V
VOLTAGE
SELECTOR
127V
110V
Voltage arrow
EN01-09UX-A52[UNUSUJ]_f 01.12.21, 21:189