Filter
Top Products
– 15 –
English
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
When shipped, the built-in AM tuner is set to 9 kHz
spacing. You can change it to 9 kHz or 10 kHz spacing.
On the unit ONLY:
To set the AM tuner to the 10 kHz spacing, be sure that
the unit is turned off, but is plugged into a wall outlet.
While holding ¢, press
STANDBY/ON. The unit
turns on and “AM 10 kHz” appears on the display for a
while.
To set it back to the 9 kHz spacing, be sure that the unit is
turned off, but is plugged into a wall outlet.
While holding 4, press
STANDBY/ON. The unit
turns on and “AM 9 kHz” appears on the display for a
while.
Tuning in a Station
1
Press FM/AM repeatedly to select “FM” or “AM.”
The unit automatically turns on with the last selected
station.
• Each time you press the button, the band alternates
between FM and AM.
2
Press and hold ¢ or 4 until the station
frequencies start changing on the display.
• ¢ : to increase the frequencies.
• 4 : to decrease the frequencies.
The unit starts searching stations and stops when a
station of sufficient signal strength is tuned in.
• If an FM program is broadcast in stereo, the ST
(stereo) indicator lights on the display.
To stop during searching, press ¢ or 4.
When you press ¢ or 4 repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is noisy or hard to receive,
you can change the FM reception mode to improve the
reception.
On the remote control ONLY:
Press FM MODE so that the MONO indicator lights on
the display.
• Each time you press the button, the MONO indicator
lights and goes off alternately.
When the MONO indicator is lit:
Reception improves though stereo effect is lost.
When the MONO indicator is not lit:
You can hear stereo sound when a program is
broadcast in stereo.
The ST (stereo) indicator lights while receiving
the FM stereo broadcast (only when the reception
is good.)
In addition, static noise between stations will be
erased while tuning.
Presetting Stations
You can preset 30 FM and 15 AM stations manually.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step
2
again.
On the remote control ONLY:
1
Tune in a station you want to preset.
• See “Tuning in a Station” to the left column.
2
Press SET.
The preset number starts flashing as follows:
• When you select an FM station in step
1
• When you select an AM station in step
1
Ex. An FM station is tuned in.
Preset No. 1 always appears at first.
EN14-16UX-A52[UNUSUJ]_f 01.12.21, 21:1815