Filter
Top Products
5
⁄
Digital audio component
• Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu
correctly according to the connected digital audio
equipment (see page 33). If
the
setting is incorrect, loud
noise may be generated causing damage to the speakers.
• Digital audio signals are output from this System only when
“DVD/CD” is selected as the source.
@
Speakers
• When connecting the speaker cords, match the polarity of
the speaker terminals: red color to (+) and black color to (–).
• By using QP Link (Quick Portable Link), you can easily
start playing back a portable audio device on this unit when
connecting it to the LINE IN jack. See page 11 for details.
• Connect an audio component to the LINE OUT jack if the
component is not equipped with a digital input terminal.
• If an external device is not equipped with a stereo mini plug
audio output, use a plug adaptor to convert the stereo mini
plug to the corresponding plug of the audio output.
Preparing the remote control
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
When using the remote control
Point the top of the remote control toward the remote sensor
as directly as possible. If you operate it from a diagonal
position, the operating range (approx. 5 m) may be shorter.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
Protective cap
CAUTION:
From right
speaker
From left
speaker
Red
Black
Press and hold
Release
Insert
When connecting a portable audio device (LINE)
DO NOT recharge, short, disassemble, heat
the battery or dispose of it in a fire.
Stereo mini plug
(not supplied)
At the front panel
Portable audio device
(Digital Audio Player, etc.)
Portable audio device with
the audio input
(Digital Audio Player, etc.)
To the audio output
To the audio input
R6(SUM-3)/AA(15F)
UX-G70[B].book Page5 Monday, April 17, 2006 1:41 PM