Filter
Top Products
16
DIGITAL IN
2(VIDEO)
1(DVR/DVD)
3(TV)
DIGITAL OUT
PCM/STREAM
NOTES
• When shipped from the factory, the DIGITAL IN terminals on the
rear of the receiver have been set for use with the following
components:
– 1(DVR/DVD): For DVD recorder or DVD player
– 2(VIDEO): For the component connected to the VIDEO
IN jacks on the rear of the receiver
– 3(TV): For TV
If you connect other components, change the digital input
(DIGITAL IN) terminal setting correctly. See “Setting the digital
input (DIGITAL IN) terminals—DIGITAL IN 1/2/3” on page 31.
• Select the correct digital input mode. See “Selecting the audio
input setting” on page 20.
Digital audio connection
This receiver is equipped with three DIGITAL IN terminals—one
digital coaxial terminal and two digital optical terminals—and one
DIGITAL OUT terminal on the rear of the receiver.
To reproduce the digital sound, use the digital audio connection in
addition to the analogue audio connection methods described on
pages 10 to 15.
Digital coaxial cable (not supplied)
Digital optical cable (not supplied)
Turn off all components before making connections.
• When you connect other components, refer also to their
manuals.
7 Digital input terminals
When the component has a digital coaxial output
terminal, connect it to the 1(DVR/DVD) terminal,
using a digital coaxial cable (not supplied).
When the component has a digital optical output
terminal, connect it to the 2(VIDEO) or 3(TV)
terminal, using a digital optical cable (not supplied).
Before connecting a digital
optical cable, unplug the
protective plug.
NOTES
• The digital signal format transmitted through the DIGITAL OUT
terminal is the same as that of the input signal. For example,
when the DTS signals are coming, the DTS signals are
transmitted.
• The digital audio signals coming through the following terminals
cannot be transmitted through the DIGITAL OUT terminal:
– USB WIRELESS ANTENNA terminal
– USB terminal
– HDMI VIDEO (VCR) IN terminal and HDMI DVR/DVD IN
terminal
Connecting the power cord
When all the audio/video connections have been made, connect
the AC power plug to the wall outlet. Make sure that the plugs are
inserted firmly. The standby lamp lights in red.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not alter, twist or pull the power cord, or put anything heavy
on it, which may cause fire, electric shock, or other accidents.
• If the cord is damaged, consult a dealer and have the power
cord replaced with a new one.
NOTES
•Keep the power cord away from the connecting cables and the
antenna. The power cord may cause noise or screen
interference.
• The preset settings such as preset channels and sound
adjustment may be erased in a few days in the following cases:
–When you unplug the power cord.
–When a power failure occurs.
• When you unplug the power cord with the receiver on and
connect the power cord again, the receiver enters standby
mode.
7 Digital output terminal
You can connect any digital components which have an optical
digital input terminal.
Connecting digital recording equipment to the
DIGITAL OUT terminal enables you to perform
digital-to-digital recording.
16-18RX-D701S[B].p65 05.11.7, 2:54 PM16