Filter
Top Products
47
English
Operating Other Manufacturers’ Video Equipment
This remote control supplied with the receiver can transmit control signals for other manufacturers’ TVs, CATV
converters, DBS tuners, VCRs and DVD players.
When operating the other manufacturers’ components, refer also to
the manuals supplied with them.
• After replacing batteries for the remote control, you need to set
the manufactures’ codes again.
To change the transmittable signals for
operating another manufacturer’s TV
1. Press and hold TV .
2. Press TV/DBS.
For RX-8030VBK: “CALL” appears on the display window of
the remote control.
3. Enter a manufacturer’s code using buttons 1 – 9,
and 0.
See the list on page 49 to find the code.
4. Release TV .
The following buttons can be used for operating a TV:
TV
: Turn on and off a TV.
TV VOL +/–: Adjust the volume.
TV/VIDEO: Set the input mode (either TV or VIDEO).
After pressing TV/DBS, you can perform the following
operations on a TV:
CH +/–: Change the channels.
1 – 10/0, 0, 100+ (+10):
Select the channels.
The 10/0 button will function as the ENTER
button if your TV requires pressing ENTER
after selecting a channel number.
Notes:
• All the functions listed above may not be assigned to the
buttons for some TVs.
• If you cannot change the channels of some TVs by pressing
10 keys, press CH +/– for changing the channels.
5. Try to operate your TV by pressing TV .
When your TV turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of TV,
try each one until the correct one is entered.
To change the transmittable signals for
operating a CATV converter or DBS tuner
1. Press and hold CATV/DBS .
2. Press CATV/DBS CONTROL.
For RX-8030VBK: “CALL” appears on the display window of
the remote control.
3 Enter a manufacturer’s code using buttons 1 – 9,
and 0.
See the list on page 49 to find the code.
4. Release CATV/DBS .
The following buttons can be used for operating a CATV
converter and DBS tuner:
CATV/DBS
: Turn on and off a CATV converter or DBS
tuner.
After pressing CATV/DBS CONTROL, you can perform the
following operations on a CATV converter or DBS tuner:
CH +/–: Change the channels.
1 – 10/0, 0, 100+ (+10):
Select the channels.
The 10/0 button will function as the ENTER
button if your equipment requires pressing
ENTER after selecting a channel number.
5. Try to operate your CATV converter or DBS
tuner by pressing CATV/DBS
.
When your CATV converter or DBS tuner turns on or off, you
have entered the correct code.
If there are more than one code listed for your brand of
CATV converter or DBS tuner, try each one until the correct
one is entered.
Note:
You cannot preset the signals for both the CATV converter and DBS
tuner at the same time.
42-52_8030&7030[C]7.pm6 03.2.13, 2:52 PM47