Filter
Top Products
11
English
To select a programme type————
■
1.Press the EON button twice while listening
to an FM station.
“EON SELECT” apears on the display.
■
2.Select the programme type with the
4
or
¢
button (UP or DOWN button on the
Remote Control) within 10 seconds.
The display shows a programme type in the following order:
TA: Traffic Announcement
NEWS: News
INFO: Programmes on medical service, weather forecast, etc.
OFF: EON off
■
3. Press the EON button within 10 seconds
again to set the selected programme type.
The selected programme type indicator lights up on the display,
and the unit enters EON Standby mode.
• The EON indicator lights up when tuned to a station which pro-
vides EON information.
Case 1: If there is no station broadcasting the type of pro-
gramme you have selected
The broadcast station being currently heard will continue to be
heard.
«
When a station starts broadcasting the programme you have select-
ed, this unit automatically switches to the station. The programme
type (TA, NEWS or INFO) indicator starts blinking.
«
When the programme is over, this unit goes back to the currently se-
lected station, but still remains in EON Standby mode.
Case 2: If there is a station broadcasting the type of pro-
gramme you have selected
This unit tunes to the station broadcasting the programme. The pro-
gramme type (TA, NEWS or INFO) indicator starts blinking.
«
When the programme is over, this unit goes back to the currently se-
lected station, but still remains in EON Standby mode.
Notes:
• If the EON is in standby mode and the function (CD, TAPE, MD/
AUX) switch is changed or the power is switched off, then the
EON mode will be released. When the band is set to AM (MW/
LW), the EON is not activated. When the band is set to FM again,
the EON will be set to standby mode.
• When the EON is being operated (i.e. the selected programme
type is being received from the broadcast station) and if the
DISPLAY MODE or
4
,
¢
button is operated, the station
will not switch back to the current selected station even after the
programme ends. The programme type indicator remains in the
display, indicating that the EON is in standby mode.
• When the EON is in standby mode and a radio broadcast is be-
ing recorded, be careful because the EON may be activated and
a different programme than the intended one may be recorded.
When the EON mode is not required, release the EON mode.
• When the alarm signal is detected by EON, the station broad-
casting the alarm is received with priority. “ALARM!” is not
displayed.
Caution:
When the sound alternated intermittently be-
tween the station tuned in by the EON function
and the current selected station, cancel the EON
mode. This does not constitute malfunction of the
unit.
PTY/EON PTY/EON
DOWN UPMULTI CONTROL