Filter
Top Products
7
English
You can reinforce the bass sound to maintain rich, full bass at low
volume (you can use this effect only for playback):
To get the effect, press the AHB (Active Hyper Bass) PRO but-
ton.
The “BASS” indicator lights up on the display.
To cancel the effect, press the button again.
The “BASS” indicator goes out.
You can control the tone by changing the bass and treble.
The analog clock acts to display the bass and treble settings.
By pressing either the BASS or TREBLE button on the Remote
Control, you can visually see the current tone control settings.
Examples:
FLAT Fully boosted
BASS Control ———————————
You can adjust the bass level (low frequency range level) between
–6 and +6. (0: Flat)
■
1. Press the BASS button on the Remote Con-
trol.
■
2. Press the UP or DOWN button on the
Remote Control to adjust the bass level.
TREBLE Control ——————————
You can adjust the treble level (high frequency range level) between
–6 and +6. (0: Flat)
■
1. Press the TREBLE button on the Remote
Control.
■
2. Press the UP or DOWN button on the
Remote Control to adjust the treble level.
In Standby mode, the digital clock and analog clock appear on the
display at the same time. Meanwhile, only the analog clock is dis-
played when a music source is selected. Namely, you can see the an-
alog clock at all times.
When the System is turned on, you can display the digital clock at any
time.
To display the digital clock,
press the CLOCK button on the
Unit or DISPLAY button on the Remote Control.
To return to the previous mode,
press the same button again.
Note:
To let work the clock, you need to set the clock beforehand.
(See “Setting the Clock” on page 18.)
Reinforcing the Bass Sound
(AHB PRO)
Tone Control (BASS/TREBLE)
( )
( )
( )
( )
BASS
DOWN
UP
TREBLE
DOWN
UP
Showing the Time (DISPLAY)
Second Hand
Minute Hand
Hour Hand